Los Angeles & the Westside · Climate zone 9
Attic insulation in Culver City, CA
Insulation, air sealing, spray foam and clean-outs for Culver City homes, sized for a hot inland valley climate.
Culver City, CA
- Climate zone
- 9
- Climate
- Hot inland valley
- Our target
- R-38 to R-49
- Electric
- SCE
Insulating Culver City homes
Culver City is full of 1930s–50s bungalows and ranch homes, many now with second-story additions. The joint between the old roof and the new addition is a common gap, and we seal and insulate it so the upstairs is not fighting the attic below.
What we recommend in zone 9
Inland valley attics regularly pass 140°F in summer. We aim for R-38 at minimum and R-49 for homes with ducts in the attic or rooms that overheat, and we often add a radiant barrier. Every Culver City job starts with a free inspection: we measure your existing insulation, check for rodents, moisture and wiring issues, and photograph the attic so you can see it for yourself.
Neighborhoods we serve
- Carlson Park
- Culver Crest
- Blair Hills
- Jefferson Park
- Sunkist Park
Services in Culver City
What we do in Culver City
-
Attic Insulation
The right material, at the right depth, for your attic — batts, blown-in or foam.
Learn more
-
Blown-In Insulation
A deep, even blanket across the whole attic floor, usually in a single day.
Learn more
-
Spray Foam Insulation
Insulation and an air seal in one, for vaulted ceilings, bonus rooms and roof decks.
Learn more
-
Insulation Removal & Reinstall
Old, dirty or rodent-soiled insulation vacuumed out, the attic cleaned, fresh insulation in.
Learn more
-
Attic Air Sealing
Close the hidden holes between your rooms and your attic before the insulation goes on.
Learn more
-
Radiant Barrier
Reflect the sun's heat off the roof deck before it reaches your insulation.
Learn more
Reviews
What homeowners near Culver City say
What people tell us after the first hot afternoon — or the first cold night.
Our Silver Lake place was drafty and dusty no matter what we did. They sealed a ridiculous number of holes in the attic before insulating. Way less dust, and the heater does not run all night anymore.
We assumed being near the beach meant insulation did not matter. The cottage was freezing every winter. Now it holds heat, and it is a lot quieter with the street noise.
The back bedroom used to hit 88 every afternoon in August. After they blew in the new insulation, it stays within a couple of degrees of the living room. My daughter actually sleeps in there now.
FAQ
Insulation in Culver City: FAQ
What R-value should my Culver City attic have?
Culver City is in California climate zone 9 (hot inland valley). For most homes here we recommend R-38 to R-49. Inland valley attics regularly pass 140°F in summer. We aim for R-38 at minimum and R-49 for homes with ducts in the attic or rooms that overheat, and we often add a radiant barrier.
How much does attic insulation cost in Culver City?
It depends on attic size, the target R-value and whether old insulation needs to come out first. We give Culver City homeowners a free inspection and a written quote that lists square footage, depth and every prep item.
Are there rebates for insulation in Culver City?
Culver City homes get electricity from SCE and gas from SoCalGas. Utility programs change often. We will tell you what we know is active and provide documentation, but always confirm eligibility with your utility.
How soon can you come out to Culver City?
We are based in Van Nuys and schedule inspections throughout Los Angeles & the Westside. We can usually see you within a few days, and most installs are finished in a single day.
Also serving near Culver City
Free · No obligation
Book a free attic inspection in Culver City
Tell us a little about your home. We will call to set a time, inspect the attic, show you photos and give you a written quote.